최신 1z1-489 무료덤프 - Oracle SPARC M6-32 and SPARC M5-32 Servers Installation Essentials

A. Only 3x power cords need to be connected when operating the server at half load.

B. The server is designed to be powered by two utility power grids.

C. With dual-power feed set up, the first set of three power cords connected to the server are usedto supply power, and the second set of three power cords are in standby mode.

D. All six power cords must be connected, even if you are using only a single power grid.

E. You must connect three power cords (ACO, AC1, and AC2) to one power grid, and connect the remaining three power cords to a second power grid (AC3, AC4, and AC5).

A. set keyswitch off /HOSTI

B. power /HOST1 off

C. power -off /HOST1

D. stop /HOSTI

A. using Oracle Ops Center to assign components to PDomains

B. using the service processor ILOM command-line interface to assign components to PDomains

C. using the Oracle ILOM BUI to assign components to PDomains

D. accessing a Solaris domain on another host and using ipmi tool to assign components to PDomains

A. From one DCU to a different DCU, an even talks with only another even (same for odd) and hops to the odd-numbered board, if needed, on the destination DCU.

B. A DCU can communicate data only with other DCUs via the BX ASICs on the SSB.

C. From one DCU to a different DCU, all CPUs can access all PCIe slots In the destination DCU directly in one hop.

D. Within a DCU, a CPU talks to another CPU directly by using the coherency switch. The SSB is not needed.

E. From one DCU to a different DCU, even CPUs can access ail the odd PCIe slots in the destination DCU directly in one hop.

A. ASR Host

B. ASR Manager system

C. ASR Client system

D. NTP

A. The SPARC M5-32 processor has 6 cores, 24MB L3$; T5 processor ha 16 cores, 48MB L3$

B. The SPARC M5-32 processor has 16 cores, 24MB L3$; T5 processor ha 16 cores, 8MB L3$

C. The SPARC M5-32 processor has 16 cores, 48MB L3$; T5 processor ha 16 cores, 8MB L3$

D. The SPARC M5-32 processor has 6 cores, 48MB L3$; T5 processor ha 16 cores, 8MB L3$

A. Install the system regardless of the customer's decision.

B. Continue with the installation, but note the customer's decision in the sign-off document.

C. Refuse to perform the installation until the customer adheres to the EIS guidelines,

D. Do a review of the existing grounding steps taken, and then proceed with the installation.

A. Set /SP/failover on.

B. Set /SP/redundancy failover=true.

C. Start /SP/failover.

D. Set /SP/redundancy initiate_ failover_ action=true