최신 2V0-41.24 무료덤프 - VMware NSX 4.X Professional V2

문제1

Which of the following settings must be configured in an NSX environment before enabling stateful active-active SNAT?

A. An Interface Group for the NSX Edge uplinks

B. Tier-1 gateway in active-standby mode

C. Tier-1 gateway in distributed only mode

D. A Punting Traffic Group for the NSX Edge uplinks

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

문제2

A customer has a network where BGP has been enabled and the BGP neighbor is configured on the Tier-0 Gateway. An NSX administrator used the get gateways command to retrieve this information:

Which two commands must be executed to check BGP neighbor status? (Choose two.)

A. sa-nsxedge-01(tier1_sr)> get bgp neighbor

B. sa-nsxedge-01(tier0_sr)> get bgp neighbor

C. vrf 3

D. vrf 4

E. vrf 1

F. sa-nsxedge-01(tier0_dr)> get bgp neighbor

정답: B,C

설명: (DumpTOP 회원만 볼 수 있음)

문제3

What is VMware's recommendation for the minimum MTU requirements when planning an NSX deployment?

A. Configure Path MTU Discovery and rely on fragmentation.

B. MTU should be set to 1550 or less across the data center network including inter-data center connections.

C. MTU should be set to 1500 or less only on inter-data center connections.

D. MTU should be set to 1700 or greater across the data center network including inter-data center connections.

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

문제4

Which is the only supported mode in NSX Global Manager when using Federation?

A. Policy

B. Proton

C. Proxy

D. Controller

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

문제5

Which VPN type must be configured before enabling an L2VPN?

A. Policy-based IPSec VPN

B. Route-based IPSec VPN

C. SSL-based IPSec VPN

D. Port-based IPSec VPN

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제6

Where is the insertion point for East-West network introspection?

A. Host Physical NIC

B. Partner SVM

C. Tier-0 router

D. Guest VM vNIC

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

문제7

How does the Traceflow tool identify issues in a network?

A. Injects synthetic traffic into the data plane and observes the results in the control plane.

B. Compares the management plane configuration states containing control plane traffic and error reporting from transport node agents.

C. Compares intended network state in the control plane with Tunnel End Point (TEP) keepalives in the data plane.

D. Injects ICMP traffic into the data plane and observes the results in the control plane.

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

문제8

Which CLI command on NSX Manager and NSX Edge is used to change NTP settings?

A. set ntp-server

B. get time-server

C. get timezone

D. set timezone

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

문제9

Which two are supported by L2 VPN clients? (Choose two.)

A. 3rd party Hardware VPN Device

B. NSX Edge

C. NSX Autonomous Edge

D. NSX for vSphere Edge

정답: A,B

설명: (DumpTOP 회원만 볼 수 있음)

최신 2V0-41.24 무료덤프 - VMware NSX 4.X Professional V2

우리와 연락하기

유용한 링크

최신 업데이트