최신 300-630 무료덤프 - Cisco Implementing Cisco Application Centric Infrastructure

문제1

Refer to the exhibit.

Two application profiles are configured in the same tenant and different VRFs. Which contract scope is configured to allow communication between the two application profiles?

A. tenant

B. application

C. VRF

D. global

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

문제2

What are two characteristics of Cisco ACI and Spanning Tree Protocol interaction? (Choose two.)

A. MST BPDUs are flooded correctly in Cisco ACI fabric without additional configuration.

B. When a TCN BPDU is received in a VLAN, Cisco ACI flushes the endpoints for the associated encapsulation.

C. Cisco ACI must be configured as the STP root for all VLANs.

D. BPDU filter and BPDU guard can be configured on Cisco ACI leaf edge ports.

E. STP BPDUs are dropped due to MCP.

정답: B,D

설명: (DumpTOP 회원만 볼 수 있음)

문제3

Leaf 1002 receives a packet from a host attached to Leaf1001. The packet contains the MAC address. IP address, and VRF of the source. Which information does each node learn?

A. Leaf1001 learns the IP address of the source.
Spine2001 learns the IP address of the source

B. Leaf1001 learns the MAC address of the source.
Leaf1002 learns the IP address of the source.

C. Leaf 1002 learns the VRF of the source.
Leaf1002 learns the IP address of the source.

D. Leaf 1002 learns the IP address of the source.
Spine2001 learns the VRF of the source.

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제4

An engineer is configuring ACI Multi-Pod between two data centers and must plan the physical cabling in the primary data center. How must the Cisco ACI Multi-Pod topology be connected?

A. Connect leaf switch 101 and 102 in pod 1 directly to leaf switch 101 and 102 in pod 2

B. Connect spine switch 201 and 202 in pod 1 to ports on a device that is providing IP connectivity between pods

C. Connect spine switch 201 and 202 in pod 1 directly to spine switch 201 and 202 in pod 2.

D. Connect leaf switch 101 and 102 in pod 1 to ports on a device that is providing IP connectivity between pods.

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제5

An engineer is deploying a Cisco ACI fabric and discovers that the traffic to certain endpoints is dropped. The originating bridge domain is configured with hardware proxy. Which action prevents this problem?

A. Enable the ARP Flooding option under the bridge domain for Layer 3 routed traffic.

B. Disable the ARP Flooding option under the bridge domain for Layer 3 routed traffic.

C. Set the L2 Unknown Unicast option to Hardware-Proxy for Layer 2 switched traffic.

D. Set the L2 Unknown Unicast option to Flood for Layer 2 switched traffic.

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

문제6

The engineer notices frequent MAC and IP address moves between different leaf switch ports. Which action prevents this problem from occurring?

A. Disable IP bridge domain enforcement.

B. Enable endpoint loop protection.

C. Enable rogue endpoint control.

D. Disable enforce subnet check.

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제7

Refer to the exhibit.

Which three actions should be taken to implement the vPC in the Cisco ACI fabric? (Choose three.)

A. Select a common vPC interface policy group

B. Select individual switch profiles

C. Select common interface profiles

D. Select individual interface profiles

E. Select common switch profiles

정답: A,C,E

설명: (DumpTOP 회원만 볼 수 있음)

문제8

An engineer is implementing the Cisco ACI fabric but is experiencing loops detected from endpoints. When the issue was investigated, it was discovered that the packets are received with the same source IP address but from different leaf switch ports. The engineer must prevent the issue from happening in the future and make sure that the port is brought back up if it was disabled due to the loop discovered. Which set of actions must be taken to meet these requirements?

A. Enable the remote endpoint limit and set the Interface override

B. Enable the rogue endpoint and set the Error Disabled Recovery Policy

C. Enable reverse path forwarding and set the Hold Interval

D. Enable the enforce endpoint check and set the Rouge EP detection interval

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제9

What is a characteristic of application-centric design in Cisco ACI?

A. One-to-one mapping between EPGs and bridge domains Is enforced.

B. A bridge domain has only one subnet.

C. EPGs represent different application tiers.

D. It simplifies gradual migration from a traditional network.

정답: C

설명: (DumpTOP 회원만 볼 수 있음)

문제10

Where are STP BPDUs flooded in Cisco ACI fabric?

A. in the bridge domain VLAN

B. in the VNID that is assigned to the FD VLAN

C. in the native VLAN ID

D. in the access encapsulation VLAN part of different VLAN pools

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

최신 300-630 무료덤프 - Cisco Implementing Cisco Application Centric Infrastructure - Advanced

우리와 연락하기

유용한 링크

최신 업데이트