최신 350-601 무료덤프 - Cisco Implementing Cisco Data Center Core Technologies (350-601 DCCOR)
Refer to the exhibit. An engineer implements an FCoE Unified Fabric where vPC exists between N9K-A and N9K-B. To avoid rate discards, bandwidth must be regulated to account for sent traffic that exceeds the access speed.
Which set of commands completes the configuration?
Which set of commands completes the configuration?
정답: D
Drag and Drop Question
Drag and drop the technologies from the left onto the correct descriptions on the right.
Drag and drop the technologies from the left onto the correct descriptions on the right.
정답:
Drag and Drop Question
An engineer must authenticate OSPF on interfaces of the Cisco Nexus 9000 Series Switch so that:
- eth1/1 uses clear text password.
- eth1/2 uses encrypted md5 password.
Drag and drop the commands from the bottom onto the boxes in the code to complete the configuration. Not all commands are used.
An engineer must authenticate OSPF on interfaces of the Cisco Nexus 9000 Series Switch so that:
- eth1/1 uses clear text password.
- eth1/2 uses encrypted md5 password.
Drag and drop the commands from the bottom onto the boxes in the code to complete the configuration. Not all commands are used.
정답:
After a Cisco Nexus 7000 Series Switch chassis replacement, the administrator discovers that all vPC- enabled LACP port channels are reinitialized. The administrator wants to prevent this issue the next time the chassis is replaced. Which two actions must be taken to meet this requirement before the isolated device is reloaded'? (Choose two)
정답: D,E
설명: (DumpTOP 회원만 볼 수 있음)
Which action must be performed before renumbering a Cisco UCS chassis?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
An engineer must implement the FCoE on the Cisco Nexus 9000 Series Switch-based infrastructure. The deployment will contain dual-homed fabric extenders and must support jumbo frames with port channels. Which two sets of actions complete the configuration? (Choose two.)
정답: A,B
설명: (DumpTOP 회원만 볼 수 있음)
Refer to the exhibit. A user must be granted management access to the Cisco Nexus 9000 Series Switch using AAA servers. The RADIUS servers are configured to accept login requests from the same Layer 2 subnet of the switch. The user must be permitted to log in with these requirements:
- RADIUS server 1 must be used to log in via a console.
- RADIUS server 2 must be used to login via SSH.
Which two actions meet these requirements? (Choose two.)
- RADIUS server 1 must be used to log in via a console.
- RADIUS server 2 must be used to login via SSH.
Which two actions meet these requirements? (Choose two.)
정답: A,C
Which two components should be checked when a Cisco Nexus 9000 Series Switch fails to boot using POAP? (Choose two.)
정답: A,C
설명: (DumpTOP 회원만 볼 수 있음)
Drag and Drop Question
Refer to the exhibit. In a bidirectional PIM network using Phantom RP as an RP redundancy mechanism, two Cisco NX-OS routers have these requirements:
- R1 must be the active RP.
- R2 must be the backup RP that is used only if R1 is not reachable
Drag and drop the configuration steps to complete the configuration for Router 2. Not all configuration steps are used.
Refer to the exhibit. In a bidirectional PIM network using Phantom RP as an RP redundancy mechanism, two Cisco NX-OS routers have these requirements:
- R1 must be the active RP.
- R2 must be the backup RP that is used only if R1 is not reachable
Drag and drop the configuration steps to complete the configuration for Router 2. Not all configuration steps are used.
정답:
Explanation:
* It's important the RP address is NOT the loopback address but one of the other address in the subnet defined on the loopback
* By default, OSPF advertises all loopbacks as /32 so the need of 'ip ospf network point-to-point' command to advertise the subnet mask
* We hardcode the OSPF RID to avoid any duplicate RID problem in case address of Loopback1 is the highest loopback
* There is a need to define a mapping agent for auto-rp to work (not shown here)
* BSR doesn't support yet the possibility to advertise as candidate RP an IP address which is not defined on any interface. This implies that BSR cannot be used with phantom RP. We need to use either Auto-RP or static RP.
What is an advantage of streaming telemetry over SNMP?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
Refer to the exhibit. A network engineer configures the VXLAN between the routers in a data center. The VLAN 10 must be extended between routers A and B. The initial VXLAN configuration is completed on Router A.
Which configuration finishes the VXLAN configuration on Router A?
Which configuration finishes the VXLAN configuration on Router A?
정답: C
A small remote office is set to connect to the regional hub site via NSSA ASBR.
Which type of LSA is sent to the remote office OSPF area?
Which type of LSA is sent to the remote office OSPF area?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
Refer to the exhibit. An engineer must configure fabric binding on a Cisco MDS 9000 Series Switch to match the output. Which fabric database configuration accomplishes this goal?
정답: B
An engineer created a service profile in Cisco UCS Manager and associated it to a server. The engineer must create a policy if there is a disruptive change applied to the service profile.
Which policy type must be used to accomplish this goal?
Which policy type must be used to accomplish this goal?
정답: D
설명: (DumpTOP 회원만 볼 수 있음)
The VMM domain is integrated between Cisco APICs and vCenter using a distributed vSwitch.
The traffic must be blocked between a subset of endpoints in an EPG based on specific VM attributes and the rest of the VMs in that EPG. Which set of actions blocks this traffic?
The traffic must be blocked between a subset of endpoints in an EPG based on specific VM attributes and the rest of the VMs in that EPG. Which set of actions blocks this traffic?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
Drag and Drop Question
Refer to the exhibit. An engineer implements an MP-BGP deployment that must meet these requirements:
- Unicast traffic must flow through the Red link between the two
autonomous systems.
- Multicast traffic must flow through the Green link.
- BGP must be configured to carry routing information and differentiate between unicast and multicast traffic to avoid RPF check failure.
Drag and drop the SiteA commands from the right onto the blanks in the configuration on the left.
Commands can be used more than once.
Refer to the exhibit. An engineer implements an MP-BGP deployment that must meet these requirements:
- Unicast traffic must flow through the Red link between the two
autonomous systems.
- Multicast traffic must flow through the Green link.
- BGP must be configured to carry routing information and differentiate between unicast and multicast traffic to avoid RPF check failure.
Drag and drop the SiteA commands from the right onto the blanks in the configuration on the left.
Commands can be used more than once.
정답:
