최신 GB0-391 무료덤프 - H3C Constructing Secure optimized WANs v2.0

문제1

Based on SOA network architecture to enterprise IT systems into which of the following levels ? ( Select one or more )

A. base infrastructure layer

B. should application layer

C. mesh network layer

D. will then layer

정답: A,B

문제2

To clear ike to establish a secure tunnel, which of the following commands should be used ?

A. reset ike

B. reset ike sa

C. reset ipsec sa

D. reset ike tunnel

정답: B

문제3

G A good safety system should be _____ .

A. of personnel in violation of the security regime of penalties

B. indeed ensure every job has its rules and regulations to follow

C. Reward people who have long followed the safety system

D. ensure ensure safety system is capable of forming a virtuous cycle of continuous self-improvement

정답: A,B,C,D

문제4

Which of the following statements about IKE is correct is ____ .( Choose one or more )

A. IKE uses an asymmetric key algorithm when exchanging keys

B. The first phase of IKE exchange mode has main mode and quick mode

C. The exchange of keys in both IKE modes requires authentication

D. IKE SA is generated when the second phase of IKE is completed

정답: A,C

문제5

a H.323 gateway receives when registering with the gatekeeper RRJ message stating

A. network gatekeeper registration request is being processed gateway

B. Net observe accepted the registration of the gateway

C. network related parameters transmitted error

D. network gatekeeper refused to register the gateway

정답: D

문제6

Configure the following commands on the MSR router:
qos pql 1 protocol-ip-tcp1000 queue-top
qos pql 1 protocol-ip-tcp1001 queue-middle
qos pql 1 protocol-ip-tcp1002queue-normal
qos pql 1 protocol-ip-tcp1003 queue-bottom
#
interface GigabitEthernet0/1
port link-mode route
ip address 192.168.1.1 255.255.255.0
qos lr outbound cir 10000 cbs 625000 ebs 0
qos pq pql 1
qos rtpq start-port 16384 end-port 32767 bandwidth 1000 cbs 25000
Then when the destination port are 1000 , 1001 , 1002 and 1003 of the TCP packet and matching with RTPQ the flow rates of at 4Mbps speed feed into the MSR , and from the side port G0 / 1 forwarding, the following statements is correct is ______

A. Head of port 1001 of TCP packet forwarding rate is 4Mbps

B. Head of the port 1002 of TCP packet forwarding rate is 2.4Mbps

C. Head of port 1003 of TCP packet forwarding rate is 0

D. The forwarding rate of RTPQ traffic packets is about 1Mbps

E. Head of port 1000 of TCP packet forwarding rate to 3Mbps

정답: A,C,D

문제7

Which of the following H.225 messages called for the direction of the caller indicates that call processing progress state ?

A. Progress

B. Alerting

C. Setup

D. Call-proceeding

정답: A,B,D

문제8

In the PPPoE application of ADSL , when the CPE side uses the MSR router + ADSL interface card for networking, and the CO side DSLAM uses ATM for uplink, which interfaces need to be PPPoE- related on the CO side centralized router ( PPPoE Server ) Configuration ?

A. Virtual-Ethernet

B. ATM interface

C. Virtual-Template

D. dial number Interface

E. Yi Tai Ethernet port

정답: A,B,C

문제9

The following commands are configured on the S3610 switch:
qos map-table dot1p-lp
import 1 export 5
interface Ethernet1/0/8
port link-mode bridge
port link-tpe trunk
port trunk permit vlan 1 to 2
qos trust dot1p
interface Ethernet1/0/7
port link-mode bridge
port link-tpe trunk
port trunk permit vlan 1 to 2
qos gts queue 5 cir 1950 cbs 2000000
Then when the flow rate is 10Mbps the vlan id is 2 and 802.1p preferred priority of 1 is the packet from the port E1 / 0/6 enters only port E1 / 0/7 when forwarding.
Then the following statement is correct

A. portions partial misconfigured

B. 10Mbps packets are forwarded normally

C. E1 / 0 /.9 outgoing packets 802.1p preferred precedence 5

D. E1 / 0 /.9 outbound message packets 802.1p Priority Level 1

E. Packet traffic shaping is 1950kbps for forwarding

정답: B,D

문제10

Which of the following statements about SSL VPN access control is correct is ______ .

A. dynamic state does not require authorization client terminal installs

B. dynamic state authorization is not required to create a security policy

C. dynamic state authorization authorization and security policy is still the intersection of authorization

D. static state authorized authentication including local and external authentication certification in two ways

정답: C,D

문제11

Among the broadband access transmission media, the highest achievable transmission rate is ____ .

A. electric power line

B. same coaxial cable

C. no radio waves

D. Copper quality UTP

E. optical fiber

정답: E

문제12

In the basic configuration of L2TP in independent LAC mode, the correct description of the local name of the tunnel is ____ .

A. In the L2TP group view, use the Tunnel name name command to configure the local tunnel name

B. default case considered, the name of a tunnel for the name of the system

C. In the system view, use the Tunnel name name command to configure the local tunnel name

D. default case considered, the name of a tunnel is empty

정답: A,B

문제13

Which statement about the VLAN planning of the EPCN network is correct?

A. PUPSPV mode can accurately user and business equipment, each user's business has a corresponding VLAN ID identification

B. The PSPV method uses the same VLAN to mark all services of the same user , but the service quality cannot be guaranteed.

C. In PUPV mode, all users in the cell share the same business VLAN ID

D. PUPSPV mode can be precisely designated user service, each service of each user has a corresponding VLAN ID identity

정답: A,D

최신 GB0-391 무료덤프 - H3C Constructing Secure optimized WANs v2.0

우리와 연락하기

유용한 링크

최신 업데이트