최신 H12-893_V1.0 무료덤프 - Huawei HCIP-Data Center Network V1.0

A. Multi-level M-LAG is mainly used to construct a large Layer 2 network in a DCN or directly connect DCNs at Layer 2.

B. In multi-level M-LAG networking, you can manually configure the root bridge to prevent STP loops.

C. M-LAG networking can be classified into single-level M-LAG networking and multi-level M-LAG networking.

D. Multi-level M-LAG must be configured based on V-STP.

A. After a tunnel is established, if one end of the tunnel goes Down, the other end may not go Down.

B. Dynamic tunnels depend on EVPN Type 5 routes to transmit information.

C. A VXLAN tunnel is identified by a pair of VTEPs.

D. For a static tunnel, you need to manually configure the local and remote VNIs.

A. If Type 2 configurations of the two M-LAG member devices are inconsistent, the M-LAG running status may be abnormal. Compared with Type 1 configuration problems, Type 2 configuration problems are more likely to be detected and have less impact on the network.

B. If Type 2 configurations of the two M-LAG member devices are inconsistent, an alarm that indicates key and common configuration inconsistencies is generated.

C. If Type 1 configurations of the two M-LAG member devices are inconsistent, certain problems may occur, such as loops and long-period packet loss when the status is normal.

D. In loose mode, if Type 1 configurations of the two M-LAG member devices are inconsistent, the member interface on the M-LAG backup device is in Error-Down state and an alarm is generated, indicating that Type 1 configurations on the two devices are inconsistent.

A. 4

B. 1

C. 3

D. 2

A. FALSE

B. TRUE

A. FALSE

B. TRUE