최신 JN0-201 무료덤프 - Juniper networks Certified internet associate.m(jncia-m)

문제1

If all OSPF routers on a broadcast network have the same OSPF priority, what parameter is used to determine the new BDR at the time of a DR failure?

A. IP address of interface on broadcast network

B. loopback address

C. area ID

D. router ID

정답: D

문제2

When is the default routing policy applied?

A. prior to evaluating any applied policy

B. only if no policies have been applied

C. during the evaluation of every applied policy

D. after all policies have been evaluated

정답: D

문제3

Which OSPF router will advertise a Type 2 network LSA for a broadcast network segment?

A. DRother router

B. DR

C. ASBR router

D. ABR

정답: B

문제4

Given the following policy: policy-statement limit-cust { from { route-filter 10.0.0.0/8 orlonger reject; route-filter 10.0.55.0/24 orlonger; route-filter 10.0.0.0/16 orlonger accept; route-filter
0.0.0.0/0 through 0.0.0.0/32 { metric 5; accept; } } then { metric 10; accept; } What happens to the route 10.0.56.0/24?

A. The metric is set to 10, and the route is accepted.

B. The metric is set to 5, and the route is accepted.

C. The route is rejected.

D. The route is accepted.

정답: D

문제5

How do you enable interface fe-0/0/0 under the [edit protocols isis] level to form both a Level 1 and Level 2 adjacency?

A. set interface fe-0/0/0.0 level 3 enable

B. set interface fe-0/0/0.0 level 1 level 2

C. set interface fe-0/0/0.0

D. set interface fe-0/0/0.0 all level

정답: C

문제6

Which RSVP object assigns a label to the LSP?

A. Record Route Object

B. Label Object

C. Label Request Object

D. Label Assign Object

정답: B

문제7

Where must you configure a static LSP?

A. on the egress router only

B. on the ingress router only

C. on all routers along the LSP path

D. on the ingress and egress routers

정답: C

문제8

Which RP election mechanism can load balance among multiple candidate RPs by default?

A. bootstrap router

B. sparse-RP

C. auto-RP

D. static

정답: A

문제9

Which two routes may be advertised via EBGP? (Choose two.)

A. routes that do not originate in the local AS and are learned by OSPF

B. routes that originate on the local router and are injected using policy

C. routes that originate on the local router and are from protocol aggregate

D. routes that are transiting the local router and are from protocol BGP

정답: B,D

문제10

Which CLI command is used to see the current OSPF link-state database?

A. show ospf neighbor

B. show ospf link-state

C. show protocols ospf

D. show ospf database

정답: D

최신 JN0-201 무료덤프 - Juniper networks Certified internet associate.m(jncia-m)

우리와 연락하기

유용한 링크

최신 업데이트