최신 JN0-280 무료덤프 - Juniper Data Center, Associate (JNCIA-DC)

A. All leaf and spine devices must be the same model to ensure the proper load-balancing behavior.

B. All leaf devices must be configured in separate OSPF areas.

C. All spine devices must use the same router ID.

D. Interface speeds should be the same throughout the fabric to ensure that all links are utilized.

A. To prevent loops in the network.

B. To segregate broadcast domains.

C. To filter MAC addresses.

D. To restrict the rate of certain types of traffic.

A. Trunk

B. Access

C. Tunnel

D. Aggregated

A. BFD built to handle the routing table of the entire Internet, and can safely redistribute it into OSPF.

B. One BFD monitoring session can be used by multiple protocols.

C. BFD is so lightweight that each protocol will generate its own unique BFD session by default, to replace its own hello messages.

D. BFD is built to handle the routing table of the entire Internet, unlike IGPS.

A. 1

B. 3

C. 0

D. 2

A. show interfaces

B. monitor traffic

C. show vlans

D. show ethernet-switching table

A. 1

B. 3

C. 0

D. 2

A. set bgp peer

B. bgp set neighbor

C. neighbor <IP_ADDRESS> remote-as <AS_NUMBER>

D. add bgp connection

A. An interface that carries high bandwidth.

B. An interface that carries multiple VLANs.

C. An interface that carries excess traffic.

D. An interface that connects directly to powerful servers.

A. Addresses used in MPLS.

B. Special routes for interplanetary communication.

C. Unroutable addresses that are generally filtered by routers.

D. Addresses used for load balancing.