최신 JN0-362 무료덤프 - Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP)

문제1

In which situation would you disable penultimate-hop popping?

A. When you want to ensure the penultimate router can perform the destination route lookup

B. When you want to utilize a penultimate router that supports IPv6 tunneling

C. When you want to enforce the same class-of-service behavior through the entire LSP

D. When you want to bypass a penultimate router that does not support IPv6 tunneling

정답: C

문제2

Click the Exhibit button.

Your co-worker configures the ge-0/0/0 interface with an IPv6 address of 2001:db8:0:9::/64. After committing the configuration, your co-worker executes the command shown in the exhibit.
What is the fe80::206:aff:fe0e:e01/64 address in this scenario?

A. the link-local address

B. the loopback address

C. the statically assigned address

D. the multicast address

정답: A

문제3

Click the Exhibit button.

Referring to the exhibit, which statement is correct?

A. R2 is an ABR

B. R2 is an ASBR

C. R1 is a backbone router

D. R1 is an ABR

정답: A

문제4

Which two statements are correct about the BGP MED attribute? (Choose two.)

A. BGP routes require the MED attribute be defined

B. BGP assumes the MED value to be 0, if not already defined

C. BGP uses the MED value when peering to two different upstream ASs

D. BGP uses the MED value when peering to two or more connections to the same upstream AS

정답: B,D

문제5

You are deploying an RSVP-based MPLS network in your core. You must ensure that your LSPs are continually analyzing the usage levels and recalculating the best LSP. You also want to ensure that a minimal amount of traffic is lost when an LSP is re-signaled without user intervention.
Which two features must be enabled in this scenario? (Choose two.)

A. auto-bandwidth

B. adaptive

C. class of service

D. MPLS fast reroute

정답: A,D

문제6

You are asked to change the default TTL handling behavior on your Junos device to ensure that the RSVP- signaled LSPs in your MPLS network cannot be mapped.
Which configuration should be performed to accomplish this task?

A. Configure the no-propagate-ttl parameter for each LSP on the egress device

B. Configure the no-decrement-ttl parameter for each LSP on the ingress device

C. Configure the no-decrement-ttl parameter for each LSP on the egress device

D. Configure the no-propagate-ttl parameter for each LSP on the ingress device

정답: A

문제7

Click the Exhibit button.

Referring to the exhibit, which statement is correct?

A. R3 will not participate in the election process

B. R2 will be the designated router

C. R4 will be the designated router

D. R1 will not participate in the election process

정답: A

최신 JN0-362 무료덤프 - Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP)

우리와 연락하기

유용한 링크

최신 업데이트