최신 JN0-363 무료덤프 - Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP)
You configured interface ge-0/070.0 to run IS-IS. but this interface does not appear in the output of the show isis adjacency command as shown in the exhibit.
What is the problem in this scenario?
What is the problem in this scenario?
정답: D
In your RSVP network you have configured three separate LSPs to the same egress address. You have made no other configuration changes to the forwarding decisions made by the router.Which commands can you use to determine which LSP is being used to forward packets?
정답: A
What are three label operations that an MPLS-enabled router performs? (Choose three.)
정답: B,C,D
Referring to the exhibit, what is the minimum number of LSPs required to support alt four networks?
정답: D
Which Layer 2 mechanism logically groups network nodes into separate broadcast domains?
정답: C
Click the Exhibit.
Referring to the exhibit, which IS-IS router will be selected as the DIS?
Referring to the exhibit, which IS-IS router will be selected as the DIS?
정답: B
Click the Exhibit button. From the output shown in the exhibit, what would happen to a packet destined for address 172.29.3.5?
정답: C
What is the OSPFv3 router ID?
정답: C
Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the exhibit?
(Choose two.)
(Choose two.)
정답: B,C
Click the Exhibit button.
Referring to the exhibit, if there is a connection failure between router1 and router2, how much time will pass before the devices declare the BFD session dead?
Referring to the exhibit, if there is a connection failure between router1 and router2, how much time will pass before the devices declare the BFD session dead?
정답: C
Router A receives two similar route advertisements from different BGP peers.What would cause a route to be selected in this scenario?
정답: B
Which two functions are performed by the OSPF designated router? (Choose two.)
정답: A,C
설명: (DumpTOP 회원만 볼 수 있음)
Click the Exhibit button.
You have configured IPv6 over IPv4 tunneling, as shown in the exhibit. However, hosts connected to network 2001:0:0:1::0/64 cannot communicate with hosts on network 2001:0:0:2::0/64. The router R2 has a similar configuration as the R1 router.
How would you solve this problem?
You have configured IPv6 over IPv4 tunneling, as shown in the exhibit. However, hosts connected to network 2001:0:0:1::0/64 cannot communicate with hosts on network 2001:0:0:2::0/64. The router R2 has a similar configuration as the R1 router.
How would you solve this problem?
정답: D
Click the Exhibit. You are receiving the same route prefix from four EBGP neighbors.
Based on the information provided in the exhibit, which route will be selected?
Based on the information provided in the exhibit, which route will be selected?
정답: D
Which three attributes are well-known mandatory BGP attributes? (Choose three.)
정답: A,D,E
설명: (DumpTOP 회원만 볼 수 있음)