최신 JN0-663 무료덤프 - Juniper Service Provider Routing and Switching, Professional (JNCIP-SP)

문제1

Exhibit:

All networks shown in the exhibit contain more than one BGP speaker You operate ISP A and must ensure that Customer Y sends their traffic to you over the directly connected link. Customer Y is not to be used for transit into your network.
What would you do to accomplish this task?

A. Advertise routes to Customer X with the well-known no-advertise community.

B. Advertise routes to Customer Y with the well-known no-export community

C. Advertise routes to Customer Y with the custom defined 65535:65535 community.

D. Advertise routes to Customer X with the custom defined 0:0 community

정답: B

문제2

The link between CE1 and PE1 has a history of flapping To avoid the impact that flapping causes to the network you decide to use route damping Which statement is correct in this scenario?

A. Dampening is enabled on interfaces

B. Dampened routes become active when their figure of merit drops below the reuse value.

C. Dampened routes decay at a sliding rate known as half-life

D. Routes become dampened when the configured max-suppress value is reached

정답: C

문제3

Exhibit.

Referring to the exhibit, which statement is true?

A. The BGP session between R1 and R2 will establish correctly and only the met unicast NLRI will pass routing information

B. The BGP session between R1 and R2 will establish correctly and the met unicast and the met6 unicast NLRIs will pass routing information

C. The BGP session between R1 and R2 will establish correctly and only the inet6 unicast NLRI will pass routing information

D. The BGP session between R1 and R2 will fail to establish correctly due to an NLRI mismatch

정답: B

문제4

Exhibit:

You have a Layer 3 VPN established between PE-1 and PE-2 as well as between PE-1 and PE-3. You are using a route reflector (RR-1) to distribute VPN routes to your IBGP peers. You are asked to ensure that only relevant routes are sent from RR-1 to each of the PE routers.
Referring to the exhibit, which statement is correct?

A. You should use VRF export policies on RR-1 to control which routes are sent to each PE router.

B. You should use route target filtering only on RR-1 to control which routes are sent to each PE router.

C. You should use route target filtering on RR-1 and all the PE devices to control which routes are sent to each PE router.

D. You should use firewall filtering on RR-1 and all the PE devices to control which routes are sent to each PE router.

정답: B

문제5

Exhibit:

A Layer 3 VPN exists in the provider network and the CE devices are connecting to the PE devices using BGP. The PE devices are receiving BGP routes from the CE devices and the PE devices have the CE BGP routes in their respective routing tables. However, the remote CE devices are not receiving the BGP routes.
Referring to the exhibit, what is the problem?

A. A VRF target community mismatch exists.

B. The PE devices are detecting an AS loop.

C. A route distinguisher mismatch exists.

D. The CE devices are detecting an AS loop

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제6

Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

A. An AS loop will exist between CE-1 and CE-2 and the BGP routes will not be shared.

B. The CE-1 and CE-2 routes will have the same route distinguisher, which will not stop the BGP routes from being shared.

C. An AS loop will not exist between CE-1 and CE-2 and the BGP routes will be shared.

D. The CE-1 and CE-2 routes will have the same route distinguisher, which will stop the BGP routes from being shared.

정답: A,B

문제7

Exhibit.

You are using EVPN to provide Layer 2 stretched VLANs between two sites You notice that the MAC addresses in either site are not showing up on the remote site.
Referring to the exhibit, what are two ways to solve this problem? (Choose two )

A. On R2, issue the set switch-options vrf-target target: 65101:22030 command

B. On R2 issue the set protocols evpn vni-options vni 22030 command

C. On R1, issue the sec 3wicch-cpt:.cr.3 vrf-target target: 65101:22030 Command

D. On R1, issue the sec protocols evpn vni-options vni 22030 vrf-target target:65101:22030 command

정답: B,C

문제8

You have a mixed vendor EVPN environment and you need to ensure VXLAN interoperability between all devices In this scenario which statement is correct?

A. You should only use Type 6 and Type 2 routes

B. You should only use Type 2 and Type 5 routes.

C. You should only use pure Type 2 routes

D. You should only use pure Type 5 routes

정답: B

문제9

Exhibit.

A network designer wants to ensure that traffic from R2 destined for 2001 db9:ffff:ff00. '62 always traverses the R2-R1 link it that link is available Referring to the exhibit, which configuration change will satisfy this requirement?
A)

B)

C)

D)

A. Option D

B. Option C

C. Option B

D. Option A

정답: B

문제10

Exhibit:

You have the Layer 2 VPN configuration shown in the exhibit. You are asked to determine the remote site ID for ge-1/0/1.512.
In this scenario, what is the remote site ID?

A. 4

B. 1

C. 3

D. 5

정답: B

최신 JN0-663 무료덤프 - Juniper Service Provider Routing and Switching, Professional (JNCIP-SP)

우리와 연락하기

유용한 링크

최신 업데이트