최신 JN0-683 무료덤프 - Juniper Data Center, Professional (JNCIP-DC)

문제1

What are two ways in which an EVPN-signaled VXLAN is different from a multicast-signaled VXLAN?
(Choose two.)

A. An EVPN-signaled VXLAN can perform autodiscovery of VTEPs using BGP.

B. An EVPN-signaled VXLAN is less resource intensive.

C. An EVPN-signaled VXLAN features slower and more complete convergence.

D. An EVPN-signaled VXLAN can perform autodiscovery of VTEPs using IS-IS.

정답: A,B

설명: (DumpTOP 회원만 볼 수 있음)

문제2

Exhibit.

Referring to the exhibit, why is the active source field blank for the entry that uses the 00:0c:29:e8:b7:39 MAC address?

A. The host for this entry is locally connected to leaf1.

B. This entry is associated with a multicast EVPN route.

C. The ARP lookup for this host has failed.

D. The EVPN route for this host does not have a valid next hop.

정답: A

문제3

Exhibit.

Given the configuration shown in the exhibit, why has the next hop remained the same for the EVPN routes advertised to the peer 203.0.113.2?

A. The export policy is incorrectly configured.

B. The vpn-apply-export parameter must be applied to this peer.

C. EVPN routes cannot have the next hop changed.

D. The vrf-export parameter must be applied.

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제4

You are deploying a Clos IP fabric with an oversubscription ratio of 3:1.
In this scenario, which two statements are correct? (Choose two.)

A. The oversubscription ratio remains the same when you remove spine devices.

B. The oversubscription ratio decreases when you add spine devices.

C. The oversubscription ratio increases when you remove spine devices.

D. The oversubscription ratio remains the same when you add spine devices.

정답: B,C

설명: (DumpTOP 회원만 볼 수 있음)

문제5

Exhibit.

You are troubleshooting an IP fabric (or your data center. You notice that your traffic is not being load balanced to your spine devices from your leaf devices. Referring to the configuration shown in the exhibit, what must be configured to solve this issue?

A. The load-balance policy must be applied as an export policy to your BGP

B. The multipast multiple -as configuration must be configured for each peer in the BGP spine group.

C. The load-balance policy must have a from statement that matches on protocol bgp.

D. The load-balance policy must be applied to the forwarding table under the routing-options hierarchy.

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

문제6

You are deploying an IP fabric using EBGP and notice that your leaf devices are advertising and receiving all the routes. However, the routes are not installed in the routing table and are marked as hidden.
Which two statements describe how to solve the issue? (Choose two.)

A. You need to configure multipath multiple-as.

B. You need to configure loops 2.

C. You need to configure a next-hop self policy.

D. You need to configure as-override.

정답: A,B

문제7

You are deploying a new network lo support your Al workloads on devices that support at least 400 Gbps Ethernet. There is no requirement for any Layer 2 VLANs in this network. Which network architecture would satisfy this requirement?

A. an IP fabric with an EVPN-VXLAN architecture

B. an IP fabric using the EVPN-MPLS architecture

C. an IP fabric using PIM-SM to signal VXLAN overlay

D. an IP fabric using EBGP

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

최신 JN0-683 무료덤프 - Juniper Data Center, Professional (JNCIP-DC)

우리와 연락하기

유용한 링크

최신 업데이트