최신 NS0-093 무료덤프 - Network Appliance NetApp Accredited Hardware Support Engineer

문제1

On a NetApp FAS9000 system, which two field replaceable units (FRUs) are supported for replacement without takeover? (Choose two.)

A. DCPM module

B. caching module

C. I/O module

D. NVRAM module

정답: C,D

설명: (DumpTOP 회원만 볼 수 있음)

문제2

What happens when the command diskcopy is run from nodeshell?

A. It performs a low-level copy of the disk to another disk.

B. It copies the disk content to a specified volume.

C. It pre-fails a drive in an aggregate and copies it to a spare.

D. It triggers a RAID reconstruction of that disk.

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

문제3

A node has unexpectedly failed and is unresponsive through its node management interface.
Which two commands from the Service Processor are helpful to determine the root cause? (Choose two.)

A. event log show

B. system log

C. system core

D. sp status -d

정답: A,C

설명: (DumpTOP 회원만 볼 수 있음)

문제4

Following an unexpected takeover, the taken-over node is waiting for giveback. The administrator plans to perform a giveback with the option -cfo-only true.
What happens if this option is used?

A. Only a simulation of the giveback is performed.

B. Only SVM root volumes are sent back

C. Only the data aggregates are sent back.

D. Only the root aggregate is given back.

정답: C

설명: (DumpTOP 회원만 볼 수 있음)

문제5

Which two statements are correct when describing L1 and L2 Watch Dog Resets (WDR)? (Choose two.)

A. L2 WDR is initiated after 2 seconds from the event.

B. L2 WDR requests creation of a core dump before reset.

C. L1 WDR is initiated after 0.5 seconds from the event.

D. L1 WDR performs a soft reset.

정답: A,B

설명: (DumpTOP 회원만 볼 수 있음)

문제6

You are replacing a boot device on a FAS8300 system that is running ONTAP 9.10P6 software. You attach a USB memory stick to the external USB port on the storage controller but cannot access the memory stick.
What step needs to be performed to access the boot device?

A. Set the port to "enabled" with setenv.

B. The external USB port is not activated on NetApp systems.

C. Add the boot device before the BIOS is loaded.

D. You need to use ONTAP 9.11 or later software.

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

최신 NS0-093 무료덤프 - Network Appliance NetApp Accredited Hardware Support Engineer

우리와 연락하기

유용한 링크

최신 업데이트