최신 NSE7_SDW-7.0 무료덤프 - Fortinet NSE 7

문제1

Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

A. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.

B. Traffic does not match any of the entries in the policy route table.

C. The sdwan_service_id flag in the session information is 0.

D. All SD-WAN rules have the default setting enabled.

정답: B,C

설명: (DumpTOP 회원만 볼 수 있음)

문제2

Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?

A. get router info routing-table all

B. diagnose vpn tunnel list

C. get ipsec tunnel list

D. diagnose debug application ike

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

문제3

Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

A. Reverse-policy shaping mode

B. Interface-based shaping mode

C. Shared-policy shaping mode

D. Per-IP shaping mode

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제4

What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

A. A factory reset performed on FortiGate.

B. The FortiGate cloud key has not been added to the FortiGate cloud portal.

C. FortiGate has obtained a configuration from the platform template in FortiGate cloud.

D. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

E. The zero-touch provisioning process has completed internally, behind FortiGate.

정답: B,E

문제5

Refer to the exhibits.

Exhibit B -

Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?

A. port2 is referenced in a static route.

B. port1 is assigned a manual IP address.

C. port1 and port2 are not administratively down.

D. port1 is referenced in a firewall policy.

정답: D

문제6

Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

A. Set load-balance-mode source-ip-ip-based.

B. Set source 100.64.1.1.

C. Set cost 15.

D. Set priority 10.

정답: C,D

문제7

What are two benefits of using forward error correction (FEC) in IPsec VPNs? (Choose two.)

A. FEC improves reliability of noisy links.

B. FEC transmits parity packets that can be used to reconstruct packet loss.

C. FEC can leverage multiple IPsec tunnels for parity packets transmission.

D. FEC supports hardware offloading.

정답: A,B

최신 NSE7_SDW-7.0 무료덤프 - Fortinet NSE 7 - SD-WAN 7.0

우리와 연락하기

유용한 링크

최신 업데이트