최신 Network-Security-Essentials 무료덤프 - WatchGuard Network Security Essentials for Locally-Managed Fireboxes

문제1

You enable a network device monitoring application on a server with IP address 10.0.1.22. After you run the application, it reports that it cannot ping the Firebox at 10.0.1.1, and you see this log message in Traffic Monitor. What is the most likely cause of this issue? (Select one.)

A. There is no policy that allows Ping traffic from the server to the Firebox alias

B. The server IP address is on the Blocked Sites list

C. The default Unhandled Internal Packet policy is at the top of the policy set

D. There is no route on the Firebox for the 10.0.1.0/24 subnet

E. The dynamic NAT statement is not configured correctly for the 10.0.1.0/24 subnet

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

문제2

If you have only one public IP address, can you use Static NAT to enable inbound connections to both an email server and a web server on the private network? (Select one.)

A. Yes, if both servers use different ports

B. Yes, if both servers are on different private subnets

C. No, you must use Dynamic NAT to route inbound connections to more than one server

D. No, you must assign a public IP address to each server

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

문제3

What type of NAT enables clients on a private network to connect to servers on the Internet? (Select one.)

A. Hairpin NAT

B. Dynamic NAT

C. Static NAT

D. NAT loopback

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제4

If a Firebox has two trusted interfaces enabled, the default policies allow HTTPS connections between computers on different trusted networks.

A. True

B. False

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제5

A Firebox backup image includes certificates that were previously imported to the Firebox.

A. True

B. False

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

문제6

You have five public IP addresses available from your ISP. When you create a Static NAT action, you want to specify one of the public IP addresses for inbound traffic but do not see it in the IP address drop-down list.
How can you change the Firebox configuration to see additional public IP addresses in the Static NAT action?
(Select one.)

A. Add secondary IP addresses to the external interface

B. Add the IP addresses to the Dynamic NAT configuration

C. Configure 1-to-1 NAT for your entire subnet

D. Enable the Set Source IP option in the policy

E. Add the public IP addresses to the From field of the policy that uses the Static NAT action

정답: A

설명: (DumpTOP 회원만 볼 수 있음)

최신 Network-Security-Essentials 무료덤프 - WatchGuard Network Security Essentials for Locally-Managed Fireboxes

우리와 연락하기

유용한 링크

최신 업데이트